Finalizer

Analyzer

Low Cut and High Cut Modules

The Low Cut and High Cut EQ modules have two parameters:

  • Cutoff frequency
  • Type of filter, either Bessel or Butterworth

Low Cut modules reduce the level of the frequency range below the cutoff frequency, with a roll-off determined by the filter type.

High Cut modules reduce the level of the frequency range above the cutoff frequency, with a roll-off determined by the filter type.

  • Frequency can be adjusted by dragging the LC (low cut) or HC (high cut) top ball, or by using the frequency control in the Module EDIT View.
  • Filter type can be selected from Butterworth or Bessel in the type section of the Module EDIT View.

The example below is the Low Cut 80 Hz module, set to a Bessel filter type:

The example below is the High Cut 12 kHz module, set to a Butterworth type: